- Good anti-skid and anti-curling effects, affected by product size, weight, carpet back and floor contact
- Single triangular rubber mats are small in size and light in weight, provide limited force, it is recommended to use only on small carpets, not recommended for use on large carpets
- Before you buy, please consider whether the material on the back of your carpet is hard enough and smooth to avoid soft materials, fluff or other difficult materials
- To achieve good results, please keep the carpet of the back and the floor flat, dry and clean, avoid the contact of the hair, moisture and dust, especially flannelette bottomed rugs
HOW TO USE:
1.Place carpet or throw rug in desired place on floor.
2.Pull back one corner or area of the carpet or throw rug.
3.Remove the protective backing from (1) one of the Rug Grippers.
4.Adhere smooth surface directly to the underside of the carpet.
(Textured side should be up)
Note:All carpets vary – if do not stick firmly to carpet,stick Rug Tape(provided,Rug Tape Can be hand-cut) on carpet,adhere smooth surface of directly to tape, textured side down.
5.Place corner of the carpet or throw rug back in place and firmly press the corner so the textured side of adheres directly to the floor .
6.Repeat steps 1-5 for the remaining corners or other areas of the carpet.
CARE and HANDLING:
1.Gently remove it from floor and carpet.
2.Wash it with warm and soapy water.
3.Rinse and let it air dry. Once dried, it is ready to be reused!
Do not place it in the Dishwasher.
Keep away from Children and Pets.
A.Keep the ground(floor) and the back of the carpet flat, clean and dry before use. The contact surface is rough, with water, oil or dust will affect the paste effect.
B. After the use of products damp, please promptly clean, dry environment favorable to extend the service life.
(Long time humid environment, will accelerate the aging of the glue, loss of sticky, affecting the use of results.)
C. Applicable temperature range :(14-140℉)/(-10-60 ℃)
Too low temperature will affect the viscosity, too high temperature glue will melt.
D. How to clean up when you do not need it:
With a soft cloth dip alcohol or soapy water, and then gently wipe the paste site, the product will become easy to fall off the glue.